One-sentence explanation: It simulates the low-temperature and moist environment of winter to break seed dormancy. Hard-shell fruit tree seeds such as peach, apricot, birch-leaf pear, crabapple, pear and walnut must undergo stratification for successful germination in spring sowing. Direct dry sowing results in extremely low germination rate.
Key Requirements
• Temperature: 0 ~ 7°C (optimal: 2–5°C)
• Sand moisture: Squeeze into a clump with no water dripping between fingers; it falls apart easily when loosened. (Important! Too much water causes seed rot.)
• Seed-to-sand volume ratio: 1 part seed : 3–5 parts clean river sand. For large hard-shell seeds: 1 part seed : 5–10 parts sand.
Simple Home Operation (for small quantities, suitable for birch-leaf pear & pear seeds)
1. Seed selection & cleaning: Pick plump, pest-free seeds; remove pulp and debris. Soak hard-shell seeds in clean water for 1–3 days, change water daily to fully hydrate seeds.
2. Mix with sand: Rinse river sand clean, adjust to the standard moisture level, then mix evenly with seeds.
3. Container: Use breathable wooden box / flower pot / woven bag. Do NOT use sealed plastic bags (lack of oxygen causes mould).
4. Cold storage: Place in refrigerator crisper (NOT freezer), or shaded outdoor pit. Open the container regularly for ventilation.
5. Periodic inspection: Stir the mixture every 10–15 days, remove mouldy and rotten seeds. Spray a small amount of water if the sand dries out.
6. Sowing time: Sow when 30% of seeds show tiny white radicles.
Field Stratification for large seed batches (trench stratification, widely used in northern regions)
Dig a pit on high, well-drained and shaded ground, 60–80 cm deep. Spread a 10 cm layer of moist sand at the pit bottom, then place the seed-sand mixture inside. Cover with soil, leaving 10 cm from the ground surface. Insert straw bundles every 1 metre for ventilation to avoid seed spoilage from poor air circulation.

